Cisco CCNA / CCNP Home Lab: How To Configure Reverse Telnet
Occasionally, during your CCNA and CCNP studies, you'll run into a term that just doesn't quite make sense to you. (Okay, more than occasionally!) One such term is "reverse telnet". As a Cisco certification candidate, you know that telnet is simply a protocol that allows you to remotely connect to a networking device such as a router or switch. But what is "reverse telnet", and why is it so important to a Cisco CCNA / CCNP home lab setup?
Where a telnet session is started by a remote user who wants to remotely control a router or switch, a reverse telnet session is started when the host device itself imitates the telnet session.
In a CCNA / CCNP home lab, reverse telnet is configured and used on the access server. The access server isn't a white box server like most of us are used to; an access server is a Cisco router that allows you to connect to multiple routers and switches with one session without having to move a rollover cable from device to device.
Your access server will use an octal cable to connect to the other routers and switches in your home lab. The octal cable has one large serial connector that will connect to the access server, and eight rj-45 connectors that will connect to your other home lab devices. Your access server then needs an IP Host table in order to perform reverse telnet.
An IP Host table is easy to put together (and you better know
how to write one to pass the CCNA!). The IP Host table is used for local name resolution, taking the place of a DNS server. A typical access server IP Host table looks like this:
ip host FRS 2007 100.1.1.1
ip host R3 2003 100.1.1.1
ip host R1 2001 100.1.1.1
ip host R2 2002 100.1.1.1
ip host R4 2004 100.1.1.1
ip host R5 2005 100.1.1.1
ip host SW1 2006 100.1.1.1
interface Loopback0
ip address 100.1.1.1 255.255.255.255
no ip directed-broadcast
This configuration will allow you to use your access server to connect to five routers, a frame relay switch, and a switch without ever moving a cable. When you type "R1" at the console line, for example, you'll be connected to R1 via reverse telnet. If you have a smaller lab, an access server is still a real timesaver and an excellent investment. And by getting a static IP address to put on your access server, you can even connect to your home lab from remote locations!
About The Author
Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage (www.thebryantadvantage.com), home of free CCNA and CCNP tutorials, The Ultimate CCNA Study Package, and Ultimate CCNP Study Packages.
For a FREE copy of his latest e-books, “How To Pass The CCNA” and “How To Pass The CCNP”, visit the website and download your free copies!
|